English – 7
EN
can coexist. For this type of network, bear in mind that:
– the installation of mixed devices does not increase the maximum number of
devices that can be installed in the control unit (see the instructions manual of the
control unit);
– with the photocells, the configuration of the jumpers must be different between
the different TX and RX pairs included in the system, but without distinguishing
between the wireless and hardwired photocells.
You need to run the “acquisition” phase to enable the WM100 and the wireless
devices to communicate with each other via radio.
Warnings for programming:
• To locate the leds and buttons mentioned in the PHW200 and FLW200 manu-
als, see fig. 4.
• In procedures that require the insertion (or removal) of batteries in the various
devices, see the respective instruction manual.
• All the programming phases end automatically 2 minutes after the last key pres-
sed. Any changes made up to that moment are memorized anyway.
• At the end of the programming procedures, it might be necessary to run
the device search in the control unit. For this operation, follow the proce-
dure given in the instructions manual of the control unit.
5.1 - CREATE A NEW SYSTEM
01. Check that the WM100 does not already have a system memorized (flashing
red led) as explained in paragraph 7.1. If appropriate, delete the device as
shown in paragraph 5.4.1
02. Check that the FLW200 flashing light does not already have a system memo-
rized (flashing red led) as explained in paragraph 7.2. If appropriate, delete the
device as shown in paragraph 5.4.2
5
PROGRAMMING
To Next Page
Loading...
