10 – English
EN
reuse one or more of the devices installed previously on a system, to create a
new system.
5.4.1 - Deleting an WM100
01. Press and hold the WM100 button (fig. 3) for about 10 seconds and release it
after the red led comes on.
02. Press and release the WM100 button again (fig. 3): after 5 seconds the red led
will start flashing, indicating that the deletion phase has been activated. When
the flashing stops, WM100 is ready to be used on a new system.
5.4.2 - Deleting a wireless device
Caution: - PHW200 photocells do not have a manual reset procedure
since they are automatically updated if they find a WM100 radio interface
in programming mode, when the battery is inserted.
01. Press and hold the “T” button (fig. 4) on the FLW200 flashing light until led A
(fig. 4) continues to be lit red.
02. Press and release button “T” again: after 5 seconds the red “A” led starts to
flash, indicating that the deletion phase has been activated. After the flashes,
the device can be used on a new system.
To Next Page
Loading...
