Niche Zero - Deep Cleaning of Grinder Components

12
Care and Cleaning
WARNING: always make sure grinder is o and unplugged when cleaning.
Cleaning grind chute and grind cup
Use grind brush provided to clean grind chute. This can be done by
pushing the brush up the chute and twisng the brush. The grind cup can
be cleaned using hot soapy water.
Deep Cleaning
3-6 monthly depending on use, deep cleaning the Niche Zero is advisable.
Remove the lower burr and sweep arms. Do not over ghten the nut on
the top of the lower burr when reng. Hand ght will suce.
A vacuum cleaner is oponal but can be helpful in removing coee you
can't see, use the small nozzle to clean around the chamber (ensure the
springs are removed from the grind adjuster area).
Use a so microbre cloth around a nger to clean the grind dispensing
chute as high as possible.
A so toothbrush worked around the burr grinding surfaces works well.
Use a dampened so microbre cloth to clean the sweep arms and
chamber oor. Clean the adjustment threads with a dry toothbrush and
very lightly lubricate with food safe silicone grease.
Aer deep cleaning, run 18g of coee beans through the Niche Zero and
discard.