Niche Zero - Care and Cleaning Procedures; Removing Bean Funnel and Burrs

11
Care and Cleaning
WARNING: always make sure
grinder is o and unplugged when
cleaning.
1. Removing bean funnel:
Unscrew bean funnel
anclockwise about 5 turns,
unl loose and remove the
bean funnel.
2. Removing outer burrs:
Aer unscrewing bean funnel,
remove outer burr. Remove 2
springs (only if vacuuming). Use
brush to sweep clean into grind
chute and collect in grind cup
Reassemble Niche Zero when
nished.
3. Recalibraon of Niche Zero
aer cleaning (if required):
Screw bean funnel clockwise
unl nger ght (about 4
complete turns). Locate grind
size indicator (small white dot
on black bezel) and align with
calibrate mark on top of the
Niche Zero. If it does not align,
then only move black bezel so
the white dot is in line with the
calibrate mark, the Niche Zero is
now recalibrated. Once aligned,
unscrew bean funnel an-
clockwise back to chosen grind
seng.
WARNING: do not use when
set to calibrated as you will
damage the burrs.