Nico Technology 7600RF - 5 Application Software for RF Remote Controller

7600RF RF Receiver [Preliminary] User’s Manual
5 Application Software for RF Remote Controller
On the 7600RF RF Receiver an application for RF Remote Controller is
implemented, making output functionality as well as switch control functions
available.
Therefore the relevant LonMark profiles stated in Table 4.1 are implemented.
The use of network variables (NV) compiles with the LonMark standard, no
customized network variables are used. SCPT’s are used for parameterization
by applying the read/write-memory method.
Title Present
Version
Identification
LonMark Application Layer Interoperability Guidelines V3.1 078-0120-01D
The SNVT Master List and Programmer’s Guide V 8.0
The SCPT Master List V 8.0
Virtual Functional Object
RemoteControl
VirtualKeypad
NVTypeTranslator
Table 4.1 Referring document about LonMark profiles
5.1 System Scope
The 7600RF RF Receiver is equipped between Wireless and LonWorks
channels.
Each Wireless network allows then connection eight wireless RF Remote
Controller. Virtual Functional Object according to LonMark Standard can
be assigned to these output and configured.
Furthermore the 7600RF RF Receiver can act as constant RF remote
controller.
The 7600RF RF Receiver is equipped with one LonWorks communication
circuit to connect LonWorks network.
12
Rev.1.0B