Electric Power Generation
Installation and maintenance
LSA 52.3 / LSA 53.2 / LSA 54.2
Industrial Range Alternators
__________________________________________________________________________________________________
19
5. MAINTENANCE AND SERVICING
5.0 GENERAL INFORMATION
DANGER:
BEFORE ANY WORK ON THE GENERATOR, MAKE
SURE THAT THE START-UP CANNOT BE ACTIVATED
BY ANY MANUAL OR AUTOMATIC SIGNAL.
CHECK THAT ALL LOCKS ARE ENGAGED AND
FOLLOW THE SITE SAFETY PROCEDURES.
DANGER:
Before working on the machine, make sure that you
have understood the operating principles of the
system. If necessary, refer to the appropriate chapters
in this manual.
To obtain additional information on the maintenance of
sub-assemblies, refer to the chapters dealing with the sub-
assemblies concerned.
When a defective part is replaced with a spare part, make
sure that it is in good condition.
For any electrical work use electrical schematics for
assistance.
The whole machine must be kept clean.
CAUTION:
ANY OF THE CLEANING PERIODS INDICATED IN THIS
MANUAL MAY BE CHANGED (INCREASED OR
DECREASED) DEPENDING ON SITE CONDITIONS.
The air inlet and air outlet surfaces must be kept clean
(louvers can be cleaned like for the filters). Refer to
chapter 5.5.1.
CAUTION:
DIRT ENTERING THE MACHINE MAY POLLUTE AND
THUS REDUCE THE ELECTRICAL INSULATION.
CAUTION:
ANY PRODUCT (SEALANT, CLEANING PRODUCT,
ETC.) USED DURING MAINTENANCE OR CLEANING
MUST COMPLY WITH LOCAL REGULATIONS AND
ENVIRONMENTAL STANDARDS.
To Next Page
Loading...
