16
Nieco Corporation - Model MPB94
MAIN SIDE CONTROLS - EMS (ENERGY MANAGEMENT SYSTEM) OPERATION
1. FULL OPERATION
To operate the broiler in full mode, mean-
ing both the main and flex sides can be
used for cooking, turn the main on/off
switch to position two (2). Note: The cen-
ter (amber) light located under the flex
side control will come on. This means you
can cook on both sides of the broiler.
2. ENERGY SAVING OPERATION
Turn the main on/off switch to position
one (1). This will turn off the elements
and reduce the gas used by the burners
on the main side. The green light will
come on under the flex side control when
in EMS mode. EMS mode stops the main
side belt from turning so you cannot cook
on it. To resume full operation, turn the
switch to position two (2). There is a 6
minute re-heat period before the main
side belt begins to turn and you can cook
again. Note: If there is product on the
main side belt when you switch into EMS
mode, push the override button on the
back of the main side control box to dis-
charge any product left on the belt.
3. FLEX SIDE BURNER
If the BURGER button is selected on the
flex side control, the red indicator light
will come on under the control. This lets
you know that you are using an extra
burner on the flex side. If you are not
cooking Whoppers or hamburgers, we
strongly recommend pushing the
CHICKEN button on the flex control.
This will shut off the extra burner and
allow for more energy savings.
NOTE: Switching the Main On/Off Switch from position one to position two will put the broiler
in a re-heat mode and will stop the belt on the main side from moving for six minutes.
If your MPB94 is equipped with the energy management system, follow the instructions below for its
proper operation. The EMS will allow you to cut your energy usage during low volume periods.
1.
2.
3.
To Next Page
Loading...
