6 Operation
17/23 OPERATING INSTRUCTIONS FOR METAL SOLENOID-VALVES Index: 0
6 Operation
6.1 Commissioning
The valve must be correctly assembled and connected.
Danger of poisoning and environmental damage from the medium
Leakage due to leaks caused by impermissible pipeline forces.
Make sure that no tensile or compressive forces and no bending
moments act on the armature.
Overheating will destroy the alternating voltage solenoids
When commissioning the valve equipped with an alternating voltage
solenoid, make sure that the solenoid coil is mounted on the plunger
guide.
§ On the Types EV04-05 and MV04-05, make sure that the required differential pressure is
applied between the valve inlet and valve outlet.
§ After it is first exposed to pressure and operating temperatures, check that the valve is leak-
tight.
To Next Page
Loading...