nifty TM40 - Inspection;Service;Pre-Hire Check List

TM Series
Operating & Safety Instructions
USA – 06/11
Issue 01
33
6.3 Inspection/Service/Pre-Hire Check list
MACHINE SERIAL NO
TOWING
PASS
FAIL
N/A
Operation of tow coupling
Operation of handbrake
Operation of jockey wheel
OUTRIGGERS
Micro-switches secure
Locating pins operating freely and oiled
Outriggers operate smoothly
Operation of each micro-switch and klaxon (if fitted)
Operation of jack control valve and buttons
Operation of each hydraulic outrigger
Operation of each micro-switch including siren
Operation of boom rest micro-switch
AXLES, WHEELS AND BRAKES
Axles are secure
Wheels are secure, tire condition acceptable
Wheel bearings OK
Fenders are secure
Locating pins operate freely and oiled
Lock bolts are tight
Wheels spin freely when handbrake is released
Brakes come on equally when handbrake is applied
Brake linkages and cables secure
Brake shoe wear not excessive
Breakaway cable fitted and operable
Lighting board fitted, lights function
Tire pressure correct
Wheel nut torque correct
BASE
Operation of base control valve and buttons
Operation of all booms over full range
Cylinders are silent
Basket is level over full range
Booms, levelling rods not damaged or distorted
Booms, levelling rods, cylinders not fouling
Hoses not tight, kinked or fouled
Operation of emergency hand pump
Traction Drive System securely attached to axle