Nikon COOLPIX 4800 - Turning the Camera on; Basic Setup

12
First Steps
13
First Steps
Turning the Camera On Basic Setup
3
Highlight Ye s.
*
DATE
DATE
Set time and date?
Set time and date?
No
Yes
2
DATE
DATE
Set time and date?
Set time and date?
No
Yes
Confi rmation dialog displayed.
* Select No to exit to mode selected with mode dial. If time and date are not set,
(“date not set”) icon will fl ash in monitor during shooting and all pictures will have
time stamp of “0000.00.00 00:00.” Movies will be dated “2004.01.01 00:00.”
5
HOME TIME ZONE
HOME TIME ZONE
London
,
Casablanc
a
B
ack
Set
Display map of world time zones.
4
TIME ZONE
TIME ZONE
01. 01 . 2004 00 : 00
DaylightSaving
London, Casablanca
TIME ZONE menu displayed.
†
† To turn daylight saving time on or off, press multi selector down to highlight
DaylightSaving and press center of multi selector. When DaylightSaving is
checked, time will automatically be advanced one hour ( 94). To return to Step 4,
press multi selector up to highlight current time zone.
The Camera Clock
The camera clock is less accurate than most watches or household clocks. Check the
clock regularly against more accurate timepieces and reset as necessary.
Press the power switch until the power-on lamp lights.
The fi rst time the camera is turned on, the language-se-
lection dialog shown opposite will be displayed; choose
a language and set the time and date as described on
the following pages.
Tur ning the Camera Off
To turn the camera off, press the power switch again. The camera is off when the
power-on lamp is off. Do not remove the battery or memory card or disconnect the AC
adapter until the power-on lamp has gone out.
Auto Power Off ( Standby Mode)
If no operations are performed for one minute, the monitor and electronic viewfi nder
will turn off automatically and the camera will enter standby mode to reduce the drain
on the battery. While the camera is in standby mode, the power-on lamp will fl icker.
The camera will be reactivated when you:
• Press the power-on switch
• Press the button or press the shutter-release button halfway
• Press the button to play pictures back
• Press the button to display the menu for the current mode
• Rotate the mode dial to select a new mode
The length of time before the camera enters standby mode can be changed using the
Auto off option in the setup menu ( 98).
If no operations are performed for three minutes after the camera enters standby
mode, the camera will turn off automatically and the power-on lamp will go out.
The Power-on Lamp
The power-on lamp shows camera status as follows:
The fi rst time the camera is turned on, a language-selection dialog will be
displayed. Choose a language and set the time and date as follows:
1
Cancel Set
日本語
Deutsch
English
Es
p
añol
Français
Italiano
Nederlands
Svenska
Highlight Deutsch (German), English,
Español (Spanish), Français (French),
Italiano (Italian), Nederlands (Dutch),
Svenska (Swedish),
(Japa-
nese), (Simplifi ed Chinese),
(Traditional Chinese), or
(Korean).
*
* Press button to exit to without selecting language.
Off Off
On On
Flickers Auto power off (standby mode)
Power-on lamp Camera
Blinks Battery exhausted ( 15)
$00_Q02145_En 12-13 2004.6.1, 4:12:05 PM