E76
The Setup Menu
Reference Section
Auto Off
If no operations are performed for a specified amount of time, the monitor turns
off and the camera enters standby mode (A23).
This setting determines the amount of time that passes before the camera enters
standby mode. You can select 30 s, 1 min (default setting), 5 min, or 30 min.
C When the Monitor Has Turned Off to Save Power
• When the camera is in standby mode, the power-on lamp flashes.
• If no operations are performed for approximately another three minutes, the camera will turn off
automatically.
• When the power-on lamp is flashing, pressing any of the following buttons will turn the monitor
back on:
Power switch, shutter-release button, A button, c button, or b (e movie-record) button
C Notes About Auto Off
• The time that passes before the camera enters standby mode is fixed in the following situations:
- When a menu is displayed: 3 minutes
- During slide show playback: Up to 30 minutes
- When the AC adapter EH-62F is connected: 30 minutes
• The camera does not enter standby mode when transferring images using an Eye-Fi card.
Press the d button M z tab M Auto off
To Next Page