E102
Reference Section
Auto Off
If no operations are performed for a specified amount of time, the monitor turns off and the
camera enters standby mode (A25).
This setting determines the amount of time that passes before the camera enters standby
mode. You can select 30 s, 1 min (default setting), 5 min, or 30 min.
C When the Monitor Has Turned Off to Save Power
• When the camera is in standby mode, the power-on lamp flashes.
• If no operations are performed for approximately another three minutes, the camera will turn off
automatically.
• When the power-on lamp is flashing, pressing any of the following buttons will turn the monitor
back on:
Power switch, shutter-release button, A button, c button, or b (e movie-record) button
C Notes About Auto Off
• The time that passes before the camera enters standby mode is fixed in the following situations:
- When a menu is displayed: Three minutes minimum (or 5 min or 30 min, if these settings are
selected)
- During slide show playback: Up to 30 minutes
- When the AC Adapter EH-62G is connected: 30 minutes
- When an audio video cable or HDMI cable is connected: 30 minutes
• The camera does not enter standby mode when transferring images using an Eye-Fi card.
Tap F M z (setup menu) M Auto off
To Next Page
Loading...
Need help?
General
