(3) Pull the film leader across and place it as indicated (FILM TIP) in the figures. Be
careful not to let the leader extend too far, as it may cause excessive film slackness.
Make sure the film rests flat between the guides and over the sprocket teeth. (Figs.
D and E)
(4) Close the back cover until you hear a click indicating that it is securely locked. If the
cover does not close properly with the film in place, check that it is lying flat between
the guides and that the cartridge is snug in the chamber.
(5) Depress the shutter release button halfway after the cover has been closed, and the
film will advance automatically to frame counter number T.
NOTE:
The counter will only work with the film properly installed in the camera. If the
film counter does not advance, repeat steps (1) to (5).
Holding the Camera (Fig. F)
The camera must be held correctly with both hands, to ensure consistently good, sharp
photographs.
It should be held steadily and comfortably while you are taking photographs.
The illustrations in Fig. F show the correct ways to hold the camera in both the vertical
and horizontal positions.
Be careful not to block any window on the front with your fingers.
— 5 —
5
To Next Page
Loading...
