Nikon MD-E - Single· Frame Shooting; Continuous Shooting; Unloading the Film

II. ACTUAL SHOOTING
A. Single· Frame Shooting
1. Set the power switch to ON.
2. Depress the camera 's shutter reo
lease button, and remove your
finger immediately.
Q
B. Continuous Shooting
1. Set the power switch to ON.
2. Pr ess the came ra 's shutter re o
lea
se button, and hold it until the
desired number of frames has
been advanced. The motor
drive's framing speed depends
on the shutter speed. You can
obtain a maximum framing
speed of approximately
two
frames per seco nd with shutter
speeds of
1/90 sec. to 1/ 1000
sec. 0
Note: In both single-frame and continuous
shooting, the LED pilot tamp " blir.ks" while
mo t orized shoo tin g is in progress.
Manual Override: To resume normal
shooting
(I.e. , non·motori zed), without
removing the motor drive from the
camera,
si mply set the motor drive's
power switch to OFF, and advance
the film manually.
III. UNLOADING THE FILM
As soon as the last frame has been
advanced, the motor will automa·
tically stop and the
LED pilot lamp
will remain continuously lit.
You can
then unload film, even with the motor
drive attached to the camera.
0
7
1. Set the motor drive 's power
switch to
OFF.
2. Press the motor drive's film re o
wind button.
41
3. Rewind film by rotating the
camera's film rewind crank in the
direction
of the arrow engraved
on the film rewind knob until
rewind "tension" gets lighter. For
other details, refer to your
camera's Owner's Manual.
0