INSTALLING
BATTERIES
• Make sure the power switch is set
at OFF position .
• NiCd batteries that have
"+"
terminals exceeding 6mm
in
diameter cannot
be
used.
• Manganese batteries are not
recommended for use at low
temperatures.
• See page 133 for "NOTES
ON
BATTERIES."
3
Install four AA-type alkaline-
manganese, NiCd
or
high-
performance manganese batteries with
"+" and
"-"
terminals positioned as
shown inside holder.
1
4
Loosen battery holder lock screw
with a coin or similar object.
Retum battery holder to battery
chamber.
2 Remove battery holder.
5
Press holder into place as you
tighten lock screw with coin.
13
To Next Page
Loading...
