5 Menu Key
124 Pulse Laser Station NPL-302 Series Instruction Manual
Traverse
To open the Traverse (2Pt Angle) function, press
[2] or select Traverse in the Input menu.
Traverse function calculates a new point based on
the two defined points and angle, horizontal and
vertical distances from the line defined by those
two points.
To enter P1 and P2, enter point names or take
measurements to targets.
Enter the plus-minus angle, horizontal distance,
and vertical distance from the baseline defined by
P1-P2.
If you do not enter a value in the dVD field, the
value 0.0000 is used.
When you press
[ENT] in the dVD field, a new
point is calculated. The PT name defaults to the
last recorded PT + 1.
To record the new point and return to the point
input screen, press
[ENT].
P1 (base PT) defaults to the previously recorded
PT. P2 defaults to the previous P1.
To continuously calculate a new point, enter +Ang, HD, and dVD from the previous
bearing line. This is a convenient way to enter Traverse points.
To Next Page
Loading...
Need help?
General
