10 Error Messages
210 Pulse Laser Station NPL-302 Series Instruction Manual
Recording Data 10.8
DATA FULL 108.1
The data storage is full.
Press any key to return to the Basic Measurement Screen (BMS). Then:
DUPLICATE PT 108.2
The input PT you are trying to record already exists in the current job. An existing
coordinate record cannot be overwritten by measured data.
Press any key to return to the point input screen. Change PT.
Duplicate PT 108.3
The input PT you are trying to record already exists in the current job as an SS, SO,
or CP record. An existing SS, SO, or CP record can be overwritten by measured
data.
No Open Job 108.4
No job is open.
To ... Go to ...
delete unnecessary data
MENU > Data
delete jobs
MENU > Job
To ... Press ...
return to the PT input screen [ESC] or the
Abrt softkey
record RAW data and update XYZ data the
XYZ softkey
record RAW data only the
RAW softkey
To ... Press ...
open the job list, if there are existing jobs [1] or select
Select job
create a new job [2] or select Create job
return to the previous screen [ESC]