Why does the ready-light blink for 3 seconds at 4 Hz on my Nikon Camera Accessories?
If the ready-light blinks for 3 seconds at 4 Hz on your Nikon Camera Accessories, it indicates that underexposure may have occurred. You can resolve this by: * Shortening the shooting distance. * Setting the camera’s aperture to a larger value (f/3.5, f/4.5 or f/5.6). * Increasing the camera's ISO sensitivity.
What to do if the ready-light on my Nikon SB-400 blinks for 40 seconds?
If the ready-light blinks for 40 seconds at 2 Hz, this indicates that the battery power is low. You should replace or recharge the batteries.
Why does the ready-light in the viewfinder blink for 3 seconds after firing my Nikon SB-400 Camera Flash?
The ready-light in the viewfinder blinks for 3 seconds after firing because underexposure may have occurred. To resolve this: * Shorten the shooting distance. * Set the camera’s aperture to a larger setting (f/3.5, f/4.5 or f/5.6). * Increase the camera's ISO sensitivity.
What to do if the ready-light blinks for 40 sec at 2 Hz on my Nikon SB-400 Camera Flash?
If the ready-light blinks for 40 seconds at 2 Hz, it typically means the battery power is low. You should replace or recharge the batteries to resolve this issue.
Why does the ready-light in the viewfinder blink for 3 sec after firing my Nikon Camera Flash?
If the ready-light in the viewfinder of your Nikon Camera Flash blinks for 3 seconds after firing, it may indicate underexposure. To correct this, you can try shortening the shooting distance, setting the camera’s aperture to a larger setting (f/3.5, f/4.5, or f/5.6), or increasing the camera's ISO sensitivity.
What to do if the ready-light blinks at 1 Hz on Nikon Camera Accessories?
If the ready-light blinks at 1 Hz on your Nikon Camera Accessories, it means the body temperature has become high due to repeated flashing or another cause. Wait until the body temperature drops, and the ready-light turns on again.
What to do if the ready-light blinks for 40 seconds at 2 Hz on Nikon Camera Accessories?
If the ready-light on your Nikon Camera Accessories blinks for 40 seconds at 2 Hz, it indicates that the battery power is low. Replace or recharge the batteries to resolve this issue.
Why does the ready-light blink for 3 seconds after firing on my Nikon Camera Accessories?
If the ready-light in the viewfinder of your Nikon Camera Accessories blinks for 3 seconds after firing, it suggests underexposure may have occurred. To correct this: * Shorten the shooting distance. * Set the camera’s aperture to a larger setting (f/3.5, f/4.5 or f/5.6). * Increase the camera's ISO sensitivity.
How to fix ready-light blinking after firing on Nikon Camera Accessories?
If the ready-light in the viewfinder of your Nikon Camera Accessories blinks for 3 seconds after firing, it could be due to underexposure. To correct this: * Shorten the shooting distance. * Set the camera’s aperture to a larger setting (f/3.5, f/4.5, or f/5.6). * Increase the camera's ISO sensitivity.
Why is the ready-light blinking rapidly on my Nikon SB-400 Camera Flash?
The SB-400 is mounted to a camera which is not compatible with CLS (SB-400 is usable only with cameras compatible with CLS).
Crucial safety instructions to prevent injury and product damage.
Introductory remarks about the Speedlight manual and its purpose.
Instructions to verify all items included in the product package.
Guidance on compatibility with Nikon and third-party equipment.
Recommends test shots, regular servicing, and online support resources.
Lists compatible cameras and identifies Speedlight components.
Step-by-step instructions for battery installation and usable battery types.
Guide on securely mounting the SB-400 to the camera and adjusting the flash head.
Instructions for powering on the unit and configuring camera settings.
Information on the effective flash distance based on camera settings.
Explains Slow-sync, Red-eye reduction, Rear-curtain sync, FV Lock, and manual modes.
Details on adjusting flash output and exposure for creative control.
Introduction to using bounce flash for softer lighting effects.
Practical advice for successful bounce flash photography.
Advice on correcting mottled appearance and improving illumination.
Details TTL Remote Cord SC-28/17 and provides care/storage guidelines.
Precautions for temperature, environment, and battery handling.
Guidelines for continuous firing, camera compatibility, and microcomputer notes.
Comprehensive technical and performance data for the SB-400 Speedlight.
Crucial safety instructions to prevent injury and product damage.
Introductory remarks about the Speedlight manual and its purpose.
Instructions to verify all items included in the product package.
Guidance on compatibility with Nikon and third-party equipment.
Recommends test shots, regular servicing, and online support resources.
Lists compatible cameras and identifies Speedlight components.
Step-by-step instructions for battery installation and usable battery types.
Guide on securely mounting the SB-400 to the camera and adjusting the flash head.
Instructions for powering on the unit and configuring camera settings.
Information on the effective flash distance based on camera settings.
Explains Slow-sync, Red-eye reduction, Rear-curtain sync, FV Lock, and manual modes.
Details on adjusting flash output and exposure for creative control.
Introduction to using bounce flash for softer lighting effects.
Practical advice for successful bounce flash photography.
Advice on correcting mottled appearance and improving illumination.
Details TTL Remote Cord SC-28/17 and provides care/storage guidelines.
Precautions for temperature, environment, and battery handling.
Guidelines for continuous firing, camera compatibility, and microcomputer notes.
Comprehensive technical and performance data for the SB-400 Speedlight.
General| Flash modes | Manual, Red-eye reduction |
|---|---|
| Compatibility | D700, D300, D7000, D90, D5100, D5000, D3100, D3000, D60, D40 |
| Product color | Black |
| Approx. number of flashes | 140 |
| Approximate recycling time | 3.9 s |
| Camera brands compatibility | Nikon |
| Brand specific flash systems | i-TTL (Nikon) |
| Guide number (ISO 100, set at 35mm zoom) | 21 m |
| Battery type | AA |
| Number of batteries supported | 2 |
Weight and Dimensions| Depth | 80 mm |
|---|---|
| Width | 66 mm |
| Height | 56.5 mm |
| Weight | 127 g |
| Dimensions (WxDxH) | 66 x 80 x 56.5 mm |
To Next Page
