near electrical devices, route the speaker wires several feet
away from the electrical wiring.
Using the SVL-2 with Tube-Type Amplifiers
Virtually all tube amplifiers must have a load connected at all
times. If the amplifier to be connected to the SVL-2 is a tube
amplifier, be sure to always have at least one pair of speakers
switched on at all times. An alternative is to permanently
connect a 150 ohm, 5 watt resistor across the tube amplifier's
output in parallel with the SVL-2. See (Figure 1) for hookup
diagram.
6
S
PEAKER
S
ELECTION
/V
OLUME
C
ONTROL
S
YSTEM
Figure1
Using a
Tube Amplifier
To Next Page
Loading...
