Nilfisk-Advance BR 855 User Manual

Nilfisk A/S
Kornmarksvej 1
DK-2605 Brøndby
Denmark
Tel.: +45 43 23 40 50
Fax: +45 43 43 77 00
mail.com@nilfisk.com
www.nilfisk.com
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
Use and Maintenance
- BR 755/855
ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual
2. Check that the drive pedal is
responding and all circuit breakers
are armed.
1. Check battery charge gauge.
3. Check battery cables are well
connected together.
4. Recovery tank seal cover must
correctly installed and in good
condition.
16. In case something does not work
enter the Service test mode by
pressing the scrub ON switch and the
Vacuum switch together and turn on
the key. Go through the menu.
13. Make sure that deck and squeegee
are moving down when pressing
the button.
11. Install Brushes.
12. Adjust side skirts height
14. Adjust water flow.
15. Adjust detergent flow.
7. Check the height of the squeegee by
adjusting the castor wheels.
5. Inspect the squeegee blades for cuts
or chunks.
6. Install squeegee. 8. Open broom door compartment
and check presence of ropes or
debris that can block it.
9. Check presence of water in the
solution tank.
10. If necessary open the solution filter
cage and clean the net.

Nilfisk-Advance BR 855 Specifications

General

Brand	Nilfisk-Advance
Model	BR 855
Category	Scrubber
Language	English

Summary

Use and Maintenance Procedures

Check Battery Charge Gauge

Verifies the battery charge level using the gauge.

Check Drive Pedal and Circuit Breakers

Ensures the drive pedal responds and all circuit breakers are armed.

Check Battery Cables

Confirms that battery cables are securely connected.

Check Recovery Tank Seal Cover

Ensures the recovery tank seal cover is correctly installed and in good condition.

Inspect Squeegee Blades

Examines squeegee blades for damage like cuts or chunks.

Install Squeegee

Procedure for installing the squeegee onto the machine.

Adjust Squeegee Height

Adjusts the squeegee height using the castor wheels.

Check Broom Door Compartment

Inspects the broom door compartment for debris or obstructions.

Check Water in Solution Tank

Verifies the presence of water in the solution tank.

Clean Solution Filter Cage

Opens the solution filter cage and cleans the net if necessary.

Install Brushes

Procedure for installing the machine's brushes.

Adjust Side Skirts Height

Adjusts the height of the side skirts.

Check Deck and Squeegee Movement

Confirms deck and squeegee move down when the button is pressed.

Adjust Water Flow

Adjusts the flow rate of water for cleaning.

Adjust Detergent Flow

Adjusts the flow rate of detergent for cleaning.

Enter Service Test Mode

Accesses service test mode by pressing specific switches and turning the key.

Troubleshooting

Machine Not Working

Checks for common issues when the machine fails to operate.

Suction Not Working

Troubleshoots issues related to the machine's suction system.

Machine Not Cleaning

Diagnoses problems preventing the machine from cleaning effectively.

Brush Not Working

Addresses issues with the machine's brush functionality.