EasyManuals Logo

Nilfisk-Advance FM810 XP User Manual

Nilfisk-Advance FM810 XP
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
2/2015 A-7 56091150 - FM810 ST, FM810 XP
ENGLISH - AINSTRUCTIONS FOR USE
MACHINE SETUP
To prepare the machine for use follow this procedure:
1 Familiarize yourself with the machine. Read all danger, warning, and caution statements and the Operation and Parts Manual before
operating the machine.
2 Install or replace the Pad (10). The pad should be replaced if it has become matted down to a thickness of 3/8” (9.5mm) or less. To install or
replace the pad, follow these instructions:
a.) Lock the Operator Handle (6) in the upright position.
b.) Tilt the machine back until it fully rests on the Handle (6).
c.) Standing over the machine, remove existing pad then center new pad over grip face.
d.) Press Pad (10) against grip face until the hooks in the driver have set in the pad. See Figure 3.
e.) Return machine to the upright position.
CAUTION!
Damage to the grip face will occur if the machine is operated without a pad or with a pad that is 3/8” (9.5 mm) or thinner.
WARNING!
Never put yourself or let others be in a position to get injured if the machine should tip or fall, while replacing the pad or changing abrasive. Injury
can occur if the machine is connected to a power source while installing the pad or abrasive. Disconnect the machine before installing the pad or
abrasive.
10
FIGURE 3
https://harrissupplyind.com - To Order Parts Call 608-268-8080

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance FM810 XP and is the answer not in the manual?

Nilfisk-Advance FM810 XP Specifications

General IconGeneral
BrandNilfisk-Advance
ModelFM810 XP
CategoryFloor Machine
LanguageEnglish

Related product manuals