*)
Optional accessories / Option depending on model
Original instruction
10
from entering into the pump. Unscrew quick
coupling. Remove fi lter with tool and clean
it. Undo nut (A). Unlatch (B) and remove
(C) cover. Clean or replace fi lter (D) in high-
pressure pump inlet. Insert fi lter and fasten
union nut. Reattach cover.
1.1 Oil filter. Clean filter: Unscrew Filter cap (1)
Clean/replace oil filter (2). Dispose of cleaning
solution/ damaged filter in accordance with the
disposal regulations.
1.2 Checking the pump oil quality: Check colour of
pump oil. If the oil has a grey or white shade,
change the oil. Top up cold pump with fresh oil
to MAX if necessary.
1.3 Changing the pump oil: Unscrew the oil drain
plug (A) on the pump housing and dispose
of the old oil in accordance with the disposal
regulations. Check the drain plug gasket and
screw in the plug again. Fill with oil and close
the oil filler plug.
1.4 Flame sensor
1)
: Remove the sensor and clean
with a soft cloth. Ensure that the sensor is
correctly seated when installing again.
EU Declaration of conformity
We,
Nilfi sk A/S
Kornmarksvej 1
DK-2605 Broendby
DENMARK
Hereby declare, that the
Product: HPW - Professional - Mobile
Description: 230V 1~, 400V 3~, 50/60Hz, IPX5
Type: MH 4M *
Are in compliance with the following standards:
EN 60335-1:2012
EN 60335-2-79:2012
EN 55014-1:2006+A1:2009+A2:2011
EN 55014-2:1997+A1:2001+A2:2008
EN 61000-3-2:2014
EN 61000-3-11:2000
EN 50581:2012
Following the provisions of:
Machinery Directive 2006/42/EC
EMC Directive 2004/108/EC
RoHS Directive 2011/65/EC
Noise Emission Directive 2000/14/EC – Conformity
assessment
procedure according to Annex V.
- Measured noise level [dB]: 72-77
- Guaranteed noise level [dB]: 88-93
Hadsund 04-03-2015
Anton Sørensen
Senior Vice President – Global R&D