Nilfisk-Advance SC6500 User Manual

Nilfisk-Advance A/S
Sognevej 25
DK-2605 Brøndby
Denmark
Tel.: +45 43 23 81 00
Fax: +45 43 43 77 00
mail.com@nilfisk-advance.com
www.nilfisk.com
ATTENTION! Do not use the machine before you have read and understood the User Manual
2. Check that the drive pedal is re-
sponding and all circuit breakers are
armed
1. Check the battery charge gauge
(and if necessary re-charge)
3. Check battery cables are well con-
nected together
4. Recovery tank seal cover must
correctly installed and in good
condition
16. In case something does not work
enter the Service test mode by press-
ing the Speed switch and the trac-
tion control switch, then on the key.
Go through the menu.
13. Make sure that deck and squeegee
are moving down when pressing
the button.
11. Install Brushes.
12. Adjust side skirts height
14. Adjust water flow.
15. Adjust detergent flow.
7. Check the height of the squeegee by
adjusting the castor wheels and the
angle knob.
5. Inspect the squeegee blades for cuts
or chunks
6. Install squeegee
8. Open broom door compartment and
check presence of ropes or debris
that can block it.
9. Check presence of water in the
solution tank.
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
10. If necessary open the solution filter
cage and clean the net.
USE & MAINTENANCE
SC6500

Nilfisk-Advance SC6500 Specifications

General

Brand	Nilfisk-Advance
Model	SC6500
Category	Scrubber
Language	English

Summary

Use and Maintenance Procedures

Pre-Operation Checks

Verify battery charge, drive pedal response, cable connections, tank seal, and blade condition.

Squeegee and Brush Setup

Install squeegee, adjust its height and angle, open broom door, and install brushes.

Fluid and System Checks

Check water presence, clean filter, verify deck/squeegee movement, adjust water and detergent flow.

Battery Recharge and Service

Instructions for battery recharge, service mode access, and red socket disconnection.

Troubleshooting: Machine Operation

Machine Not Working

Check battery charge, drive pedal, cable connections, and recovery tank seal cover.

Suction Issues

Verify suction hose installation, clean vacuum grid, check squeegee blades, and tank cover gasket.

Cleaning Performance

Check water settings, solution tap operation, and solution filter cleanliness.

Brush Malfunctions

Check brush installation, motor overload indicators, and external obstructions.