FORM NO. 56043129 - SR 1900 - 3
GENERAL INFORMATION
INTRODUCTION
This manual will help you get the most from your Nilsk rider Scrubber-Sweeper. Read it thoroughly before servicing the machine.
Note: Bold numbers and letters in parentheses and underlined indicate an item illustrated on pages 14-17 i.e. (B).
This product is intended for commercial use only.
PARTS AND SERVICE
Repairs, when required, should be performed by your Authorized Nilsk Service Center, who employs factory trained service personnel, and
maintains an inventory of Nilsk original replacement parts and accessories.
Call the NILFISK DEALER named below for repair parts or service. Please specify the Model and Serial Number when discussing your machine.
(Dealer, afx service sticker here.)
NAME PLATE
The Model Number and Serial Number of your machine are shown on the Nameplate on the machine. This information is needed when ordering
repair parts for the machine. Use the space below to note the Model Number and Serial Number of your machine for future reference.
MODEL NUMBER ________________________________________
SERIAL NUMBER ________________________________________
HOPPER SAFETY SUPPORT
WARNING!
JACKING THE MACHINE
CAUTION!
Never work under a machine without safety stands or blocks to support the machine.
• When jacking the machine, do so at designated locations (Do Not jack on the hopper) – see jacking locations (8).
Make sure the Hopper Safety Support (5) is in
place, by using the Hopper Safety Support Handle
(I) whenever attempting to do any maintenance work
under or near the raised hopper. The Hopper Safety
Support (5) holds the hopper in the raised position
to allow work to be performed under the hopper.
NEVER rely on the machine’s hydraulic components
to safely support the hopper.
To Next Page
Loading...
Need help?
General
