How to fix voltage fluctuations in Nilfisk-ALTO ATTIX 50 PC?
To address voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner, connect the cleaner to another socket closer to the fuse box. Voltage fluctuations over 7% should not occur if the impedance at the transfer point is ? 0.15 ?.
How to fix a Nilfisk-ALTO Vacuum Cleaner when the motor does not start?
If your Nilfisk-ALTO Vacuum Cleaner motor doesn't start, it could be due to a blown fuse. Connect the mains fuse. Alternatively, the overload protection switch may have tripped. In this case, switch off the vacuum cleaner and allow it to cool for approximately 5 minutes. If it still won't start, contact Nilfisk-Alto service. Finally, the motor itself may be faulty, and you should have it changed by Nilfisk-Alto Service.
Why is my Nilfisk-ALTO ATTIX 50 PC causing voltage fluctuations?
If you experience voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner, it may be due to high impedance in the power supply. To resolve this, connect the cleaner to another socket closer to the fuse box. Voltage fluctuations should not exceed 7% if the impedance at the transfer point is ≤ 0.15 Ω.
What to do if Nilfisk-ALTO ATTIX 50 PC has no suction power during wet cleaning?
If your Nilfisk-ALTO Vacuum Cleaner has no suction power during wet cleaning, it could be that the tank is full. Switch off the cleaner and empty the tank.
Why Nilfisk-ALTO Vacuum Cleaner motor does not run in automatic mode?
If the motor of your Nilfisk-ALTO Vacuum Cleaner does not run in automatic mode, check that the power tool works or that the plug is inserted correctly. Also, ensure that the power rating of the electrical tool is greater than 40W.
Why won't my Nilfisk-ALTO Vacuum Cleaner motor start?
If your Nilfisk-ALTO Vacuum Cleaner motor won't start, it could be due to a blown fuse in the mains socket. Try connecting a mains fuse. Another possibility is that the overload protection switch has tripped. In this case, switch off the vacuum cleaner and allow it to cool for approximately 5 minutes. If it still doesn't start, contact the Nilfisk-Alto service department. Finally, the motor itself might be faulty, so have it changed by Nilfisk-Alto Service.
How to fix voltage fluctuations in my Nilfisk-ALTO Vacuum Cleaner?
If you experience voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner, it's likely due to high impedance in the power supply. To resolve this, connect the cleaner to another socket closer to the fuse box.
What to do if my Nilfisk-ALTO Vacuum Cleaner has reduced suction and acoustic warnings?
If you hear acoustic warnings and notice reduced suction power in your Nilfisk-ALTO Vacuum Cleaner, several factors could be the cause. First, the suction power selected might be too low, so adjust it according to the manual's instructions. Also, the hose diameter might not match the switch position, so set the correct switch position. Check for clogs in the suction hose or nozzle and clean them if necessary. Make sure that the tank, disposal bag, or filter bag is not full. Also, the filter element may be clogged, so clean or replace it as described in the manual. Finally, make sure that the seal between the tank and the upper section of the vacuum cleaner is intact; if it's faulty or missing, replace it.
What to do if my Nilfisk-ALTO ATTIX 50 PC Vacuum Cleaner has no suction power during wet cleaning?
If your Nilfisk-ALTO Vacuum Cleaner lacks suction power during wet cleaning, it's likely that the tank is full. To resolve this, switch off the cleaner and empty the tank.
Why Nilfisk-ALTO ATTIX 50 PC Vacuum Cleaner has reduced suction power?
Reduced suction power in your Nilfisk-ALTO Vacuum Cleaner can occur for several reasons: * The suction power setting might be too low; adjust it according to the instructions. * The suction hose or nozzle may be clogged; clean them. * The tank, disposal bag, or filter bag might be full; empty the tank or replace the bags. * The filter element could be clogged; clean or replace it. * The seal between the tank and the upper section of the vacuum cleaner may be faulty or missing; replace the seal. * The cleaning mechanism might be defective, in which case you should contact Nilfisk-Alto Service.
General| Brand | Nilfisk-ALTO |
|---|---|
| Model | ATTIX 50 PC |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page
