2
english
1)
Options / model variants
Original instruction
NEPTUNE 5 / 7 / 8
1 Important instructions
Symbols used to mark
instructions
Before using the
high-pressure
cleaner, be sure
to also read the
enclosed operat-
ing instructions
and keep them within reach at
all times.
For your own safety
The high-pressure cleaner should
only be used by authorized per-
sons who have been instructed
in its use.
This appliance is not intended
for use by persons (including
children) with reduced physical,
sensory or mental capabilities,
or lack of experience and knowl-
edge.
High pressure cleaners shall not
be used by children or untrained
personnel.
Children should be supervised to
ensure that they do not play with
the appliance.
General
Use of the high-pressure cleaner
is subject to the applicable local
regulations.
Besides the operating instruc-
tions and the binding accident
prevention regulations valid in the
country of use, observe recog-
nized regulations for safety and
proper use.
Do not use any unsafe work
techniques.
Transport
Transport of the high-pressure
cleaner is easy on its large
wheels.
For safe transport in and on ve-
hicles we recommend preventing
the equipment from sliding and
tilting. Secure it with tie-downs
and apply the parking brake on
the castor wheel.
For transport at temperatures
around or below freezing 0°C
(32°F), anti-freeze should be
drawn into the pump beforehand
(see chapter 6).
Before starting the cleaner
If your 3-phase cleaner was
supplied without a plug, have
it fi tted with a suitable 3-phase
plug with ground, by a qualifi ed
electrician.
Before use, check that the high-
pressure cleaner is safe and in
proper condition.
Regularly check whether the
power cord is damaged or shows
signs of ageing.
Use the high-pressure cleaner
only when the power cord is in
a safe condition. (risk of electric
shock using damaged cord!).
Check the rated voltage of the
high-pressure cleaner before
connecting it to the mains power
supply. Ensure that the voltage
shown on the rating plate cor-
responds to the voltage of the
power supply.
We strongly recommend that the
power supply to the high pres-
sure cleaner be connected via a
residual current circuit breaker.
This device stops the supply of
electricity if the leakage current
to the ground exceeds 30 mA for
30 ms or it has an ground tester
circuit.
Please observe the regulations
and provisions applicable in
your area. Before putting the
high-pressure cleaner into ser-
vice, carry out a visual check
of all the major components.
CAUTION!
High-pressure water jets can
be dangerous if misused. The
jet must not be directed at per-
sons, animals, live electrical
equipment or the cleaner itself.
Wear appropriate protective
clothing and eye protection.
Do not direct the jet towards
yourself or towards other per-
Safety instructions
in these operating
instructions which
must be observed
to prevent risks
to persons are marked with this
danger symbol.
This symbol is used to
mark safety instruc-
tions that must be
observed to prevent
damage to the machine
and its performance.
This indi-
cates tips
and instructions
to simplify work
a n d to ensure safe opera-
tion.
Operations
marked with
this symbol
should only be
carried out by
Nilfi sk-Alto Service
Technicians.
To Next Page
Loading...
Need help?
General
