EasyManuals Logo

Nilfisk-ALTO SCRUBTEC BOOST 8 Operator's Manual And Parts List

Nilfisk-ALTO SCRUBTEC BOOST 8
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
EN
ENGLISH
Nilfisk ALTO
Operator's Manual (EN) - SCRUBTEC 866, 871, 866, Boost 8 and 871C - 11 -
How to program battery charger (WET or AGM batter-
ies):
According to the type of batteries (WET or AGM), set the
machine and electronic board of the battery charger as
follows:
Charger Setting
1. Turn the key switch “ON” (see figure 5A, item A) and
in the very first seconds of machine operation pay
attention to the following:
If the green warning light (item B) is flashing, the
charger is set to AGM.
If the yellow warning light (item C) is flashing, the
charger is set to GEL EXIDE.
If the red warning light (item D) is flashing, the
charger is set to WET.
2. If the setting is to be changed, perform the following
procedure:
a. Turn the key switch “OFF”.
b. Press and hold the buttons (items E and F) at the
same time, then turn the key switch (item A) “ON”.
c. Continue to hold the buttons (items E and F) until
the battery meter LED light turns “ON” and “OFF”
and then release both buttons.
d. Within 3 seconds, toggle the button (item F) to
advance the green bar (item G) to the desired
charger setting (see green bar position for charger
settings below):
Green bar setting (item G)
1st green bar - WET @ 25 amps, 250 & 330 ah
batteries (4 RED blinks).
2nd green bar - GEL/AGM @ 25 amps, 260 &
312 AGM (4 GREEN blinks).
3rd green bar - GEL EXIDE @ 25 amps (4
YELLOW blinks).
4th green bar - WET @ 15 amps (2 RED blinks).
5th green bar - GEL/AGM @ 15 amps (2 GREEN
blinks).
6th green bar - GEL EXIDE @ 15 amps (2
YELLOW blinks).
e. Once proper battery charger profile is selected, wait
until battery LED light quits flashing and stays on
before turning key switch “OFF”.
f. Repeat step 1 to verify that proper charger profile
was programmed for battery type (WET or GEL).
NOTE: Charge the batteries before using the
machine.
Figure 5A
HOW TO PREPARE THE MACHINE
FOR OPERATION
E
F
G
DCB
A

Other manuals for Nilfisk-ALTO SCRUBTEC BOOST 8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-ALTO SCRUBTEC BOOST 8 and is the answer not in the manual?

Nilfisk-ALTO SCRUBTEC BOOST 8 Specifications

General IconGeneral
BrandNilfisk-ALTO
ModelSCRUBTEC BOOST 8
CategoryScrubber
LanguageEnglish

Related product manuals