Adjusting the brake handles
The brake levers are made of aluminium
alloy.
Next to the brake lever is a cylinder to
adjust the tension of the wiring. Disk
brakes allow efficient braking on all
surfaces. During braking, the electrical
part of the motor is automatically
disabled.
You can adjust the brake handles to
match the position of the grips. If your
fingers, when extended from the arm,
rest on the brake levers then the brake
handles are set correctly. The wrist
should be as straight as possible when
doing so.
Pedals
The pedals on your Nilox e-bike are
suitable for closed shoes with hard soles.
Touring cycling shoes which are equally
suitable for cycling and walking are ideal.
Gear system
The rear wheel is fitted with Shimano
7speed gear (derailleur) shifter.
Its use is identical to the use of traditional
bicycle gearing and it is governed by the
classic lever located near the right-hand
handlebar.
As for traditional bycicle gearing, it must
be used with the bycicle in motion.
To Next Page
Loading...
