callipers as well as quick-release devices
and axle nuts may be very hot. Wait until
these components have cooled down be-
fore touching them.
Do not ride without the battery or without
the control console. If the battery or the
control console are not fitted then the li-
ghting system will not function. Riding
without an operational lighting system is
not permitted, depending on national re-
gulations.
Qualified specialist workshop
A qualified specialist workshop has the
necessary special skills, tools and quali-
fications to correctly carry out any neces-
sary work on your e-bike. This particularly
applies to work relevant to safety.
Always have the following work on your
e-bike carried out at a qualified specialist
workshop:
• work relevant to safety
• service and maintenance work
• repair work
• modifications, installations and con-
versions
• work on electronic components
• work on the drive system
Nilox recommends that you use a Nilox
dealer which is qualified to carry out work
on Nilox e-bikes.
Correct use
Observe the following information when
using the e-bike:
• the safety notes in the printed Ow-
ner’s Manual
• the technical data in the printed Ow-
ner’s Manual
• traffic rules and regulations
• laws and safety standards applicable
to vehicles
To Next Page
Loading...
