EasyManua.ls Logo

Ninebot ONE - Page 17

Ninebot ONE
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17 / 20
7. Remove the decorative shell (right side of the Ninebot ONE) using a Phillips-head screwdriver to
remove the four screws as shown.
8. Use a 3 mm hex key to remove the casing screws (right side of the Ninebot ONE only) then
disconnect the wiring before gently pulling the casing off.
9. Installation is in the reverse order of removal.

Table of Contents

Related product manuals