7ninjakitchen.com
6 ni njakitchen.com
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ CAREFULLY BEFORE USE • FOR HOUSEHOLD USE ONLY
WARNING
To reduce the risk of injury, fire, electrical shock or property damage,
basic safety precautions must always be followed, including the following
numbered warnings and subsequent instructions� Do not use appliance for
other than intended use�
33 DO NOT perform grinding operations
with the Single-Serve Blending Cup
and Pro Extractor Blades® Assembly,
the Stack blade assembly, or chopping
blade assembly.
34 NEVER operate the appliance
without lids and caps in place. DO
NOT attempt to defeat the interlock
mechanism. Ensure the container
and lid are properly installed before
operation.
35 Before operation, ensure all utensils
are removed from containers.
Failure to remove utensils can cause
containers to shatter and potentially
result in personal injury and property
damage.
36 Keep hands and utensils out of
containers while chopping to reduce
the risk of severe personal injury or
damage to the blender/food chopper.
A scraper may be used ON LY when
the blender or processor is not
running. When using the processor,
always use food pusher to add food.
NEVER add food by hand.
37 If you find unmixed ingredients sticking
to the sides of the cup, stop the
appliance, remove the blade assembly,
and use a scraper to dislodge
ingredients.
38 DO NOT
open pour spout cap while
blender is operating.
39 If you find unmixed ingredients
sticking to the sides of the pitcher,
stop the appliance, remove the lid, and
use a spatula to dislodge ingredients.
NEVER insert your hands into the
pitcher, as you may contact one of the
blades and experience a laceration.
40 DO NOT attempt to remove the
container or lid from the motor base
while the blade assembly is still
spinning. Allow the appliance to come
to a complete stop before removing
lids and containers.
41 If the appliance overheats, a thermal
switch will activate and temporarily
disable the motor. To reset, unplug
the appliance and allow it to cool for
approximately 30 minutes before
using again.
42 DO NOT expose the containers and
accessories to extreme temperature
changes. They may experience damage.
43 Upon completion of processing,
ensure that the blade assembly
is removed BEFORE emptying
container’s contents. Remove the
blade assembly by carefully grasping
the top of the shaft and lifting it from
the container. Failure to remove the
blade assembly before emptying the
container results in a risk of laceration.
44 If using the pour spout, hold the cover
in place on the container, or ensure
lid lock is engaged, when pouring to
avoid risk of injury.
45 Remove the Pro Extractor Blades®
Assembly from the Single-Serve
Cup upon completion of blending.
DO NOT store ingredients before or
after blending them in the cup with
the blade assembly attached. Some
foods may contain active ingredients
or release gases that will expand if
left in a sealed container, resulting in
excessive pressure buildup that can
pose a risk of injury. For ingredient
storage in the cup, use only Spout Lid
to cover.
46 The maximum wattage rating for
this appliance is based on the
configuration of the Pro Extractor
Blades Assembly and Single-Serve
Cup. Other configurations may draw
less power or current.
47 DO NOT submerge the motor base or
control panel in water or other liquids.
DO NOT spray motor base or control
panel with any liquid.
48 DO NOT attempt to sharpen blades.
49 Turn o the appliance and unplug the
motor base before cleaning.
To Next Page
Loading...
Need help?
General
