15ninjakitchen.com
14 ninjakitchen.com
1 Plug in motor base and place on a
clean, dry, level surface such as a
countertop or table.
2 Add ingredients to the Single-Serve
Cup. DO NOT add ingredients past
the MAX LIQUID line on the cup.
3 Install the Pro Extractor Blades®
Assembly onto the top of the cup.
Twist the lid clockwise until it’s sealed
tightly.
4 Turn the cup upside down and install
on the motor base. Align the tabs on
the cup with the slots on the base,
then rotate cup clockwise until it clicks
into place. Once the cup is locked
in place, press the Power button to
turn unit on. The available program
buttons will illuminate and the unit will
be ready for use.
IMPORTANT: Review all warnings on
pages 4–7 before proceeding.
NOTE: Preset programs have pauses and
changes in speed throughout the cycle.
USING THE SINGLE-SERVE CUP
5a If using an Auto-IQ® program, first select
the program that best suits your recipe.
The preset feature will automatically
stop at the end of the program. To pause
the unit at any time, press the currently
active program again.
5b If not using an Auto-IQ program, select
one of the manual programs. Once the
ingredients have reached your desired
consistency, press the START/STOP
button again, and wait for the unit to
come to a complete stop.
6 To remove the cup from the motor
base, turn the cup counterclockwise
and then lift it.
7 Remove the Pro Extractor Blades®
Assembly by twisting the cap
counterclockwise. DO NOT store
blended contents with Pro Extractor
Blades Assembly attached. Exercise
care when handling the blade
assembly, as the blades are sharp.
8 Unplug the unit when finished. Refer
to the Care & Maintenance section for
cleaning and storage instructions.
9 To enjoy your drink on the go, place
the Spout Lid onto the Single-Serve
Cup and twist lid clockwise until firmly
sealed. For storing ingredients in the
cup, use only the Spout Lid to cover.
To Next Page
Loading...
Need help?
General
