13ninjakitchen.com
12 ninjakitchen.com
1 Plug in motor base and place on a clean,
dry, level surface such as a countertop
or table.
2 Lower the Total Crushing Pitcher onto
the motor base. The handle should
be aligned slightly to the right and the
pitcher should be oriented so the LOCK
symbols are visible on the motor base.
Rotate the pitcher clockwise until it
clicks into place.
USING THE TOTAL CRUSHING® PITCHER
3 Exercising care, grasp the Stacked
Blade Assembly by the top of the shaft
and place it onto the drive gear inside
the pitcher. Note that the blade assembly
will fit loosely onto the drive gear.
4 Add ingredients to the pitcher. DO NOT
add ingredients past the MAX LIQUID
line on the pitcher.
5 Place the lid on the pitcher, aligning
the triangle symbol on the lid with the
triangle symbol on the handle. Press
down on the handle until it clicks into
place. The triangle symbols MUST be
aligned for the lid to lock and the unit to
operate. Once the lid is locked in place,
press the Power button to turn unit
on. The available program buttons will
illuminate and the unit will be ready
for use.
IMPORTANT: Review all warnings on
pages 4–7 before proceeding.
NOTE: Preset programs have pauses and
changes in speed throughout the cycle.
NOTE: The pitcher can only be installed
in one orientation. The handle must be
positioned on the front-right corner of
the motor base to operate the appliance.
NOTE: DO NOT add ingredients before
completing installation of the Stacked
Blade Assembly.
TIP:
If the Stacked Blade Assembly is not
fully seated, you will not be able to install
and lock the lid.
6a If using an Auto-IQ® program, first select
the program that best suits your recipe.
The preset feature will automatically stop
at the end of the program. To pause the
unit at any time, press the currently active
button again.
6b If not using an Auto-IQ program, select
one of the manual programs. Once the
ingredients have reached your desired
consistency, press the START/STOP
button again, and wait for the unit to
come to a complete stop.
7 To remove the pitcher from the motor
base, turn the pitcher counterclockwise
and then lift it.
8a To pour out thinner mixtures, ensure
the lid is locked in place, then open the
pour spout cap.
IMPORTANT:
As a safety feature, if the
pitcher and lid are not properly
installed,
the timer will display
“... ...”
and the
motor will be disabled. If this happens,
repeat step 5 on page 13. When the
pitcher and lid are properly installed,
the program button LEDs will illuminate,
indicating the appliance is ready to use.
8b For thicker mixtures that cannot be
emptied through the pour spout,
remove the lid and Stacked Blade
Assembly before pouring. To remove
the lid, press the RELEASE button and
lift the handle. To remove the blade
assembly, carefully grasp it by the
top of the shaft. The pitcher can then
be emptied.
9 Unplug the unit when finished. Refer
to the Care & Maintenance section for
cleaning and storage instructions.
To Next Page
Loading...
Need help?
General
