6
ninjakitchen.com
1 Review warning and caution statements above before
proceeding to number 2.
2 Place the motor base on a clean, dry, level surface.
3 Lower the pitcher onto the motor base. (Fig. 1)
4 Rotate the pitcher clockwise as far as it will go. As the
pitcher rotates, the safety tabs on the bottom of the
pitcher will slide under the safety tabs on the top of the
motor base.
(Fig. 2)
5 The pitcher can be placed on the motor base two ways;
the handle can be on the front right corner or the front
left corner. (Fig. 3a, Fig. 3b)
6 Holding the Stacked Blade Assembly by the shaft, place
it onto the gear shaft inside the pitcher. (Fig. 4) Ensure
that the Stacked Blade Assembly fits around the gear
shaft and that the blade shaft is standing straight.
NOTE: The Stacked Blade Assembly will fit loosely on
the drive gear.
7 Add the ingredients to the pitcher, making sure not to
exceed the highest measured marking line on the side
of the pitcher.
NOTE: When blending any kind of liquids, such as
drinks or smoothies, DO NOT exceed the “Max liquid”
mark (64 oz.) on the pitcher.
8 Plug the power cord into the electrical outlet.
IMPORTANT: As a safety feature, the motor will
not work if the pitcher and lid are not installed
correctly. When the pitcher and lid are installed
properly, the ready light will be solid green,
indicating that the blender is ready for use.
Fig. 2Fig. 1
ASSEMBLY
Fig. 3a
Fig. 3b
Assembly and Use of the Pitcher
WARNING: Handle the Stacked Blade Assembly with care, as the blades are sharp.
WARNING: Remove utensils prior to processing. Failure to remove may cause the pitcher to be damaged or
to shatter, which may cause personal injury.
WARNING: Never leave the appliance unattended while in use.
CAUTION: DO NOT blend hot liquids. Doing so may cause excessive pressure buildup, resulting in risk of
the user being burned.
IMPORTANT: Make sure that the motor base is plugged in for use.
OR
Shaft
Fig. 4
To Next Page
Loading...
Need help?
General