7 ninjakitchen.com6 ninjakitchen.com
PRECISION PROCESSOR®
BOWL & LID WITH
3-PART FOOD PUSHER
1.
Place feed chute lid on bowl and turn
clockwise. Based on the ingredient, use
the smallest possible feed chute opening
for best slicing and shredding results.
2B.
If using the large feed chute
opening, place ingredients
up to, but not exceeding,
the CHUTE MAX FILL line.
Insert the pusher into the
feed chute, then select
DISC or LOW. The disc
will begin spinning.
2A.
If using the small or medium
feed chute opening, select
DISC or LOW. The disc will
begin spinning. Add
ingredients through the
feed chute on the lid.
4.
Remove the disc assembly
by grasping the plastic grip,
then remove the disc spindle.
Remove bowl from base by
turning it counterclockwise,
then lifting it up.
3.
The disc will automatically
stop spinning at the end
of the program. Wait for
disc to stop turning, then
press the button on the
feed chute lid near the
handle to unlock. Turn lid
counterclockwise and lift
lid from bowl.
PROCESS & ENJOY (DISCS)
IMPORTANT: As a safety feature, the large food pusher must be inserted
in the feed chute for the unit to run.
Once the Precision Processor® Bowl is locked onto base, plug in the unit,
then press the Power button to turn the unit on.
PARTS
FOOD PREP
DISC ASSEMBLY
USING THE DISC ASSEMBLIES
2A. ADJUSTABLE SLICING
Use dial on disc to select the
desired thickness (0.3–8mm).
Then use plastic grip to carefully
place disc over disc spindle.
1.
Place Precision Processor® Bowl on base and
turn clockwise to lock in place. Install the spindle,
then choose the appropriate disc (2A or 2B).
2B. REVERSIBLE SHREDDING
Use the plastic grip to place
the disc over the disc spindle
with the desired shredding
size (either COARSE or FINE)
facing up.
NOTE: Ensure cheese is well chilled before slicing/shredding. DO NOT slice or shred frozen cheese.
NOTE: Keep ingredients as steady as possible when pushing through the feed chute.
This will help minimize waste.
ADJUSTABLE
SLICING
DISC
REVERSIBLE
SHREDDING
DISC
If using the small or medium feed chute,
trim ingredients to fit the feed chute height.
If using the larger feed chute, DO NOT
exceed the CHUTE MAX FILL line on the
large feed chute. Unit will not run if
ingredients exceed this line.
Cut both ends o ingredients to
create flat surfaces. Trim tapered
ingredients like carrots to make
them more symmetrical.
DISC
SPINDLE
FINE
COARSE
IMPORTANT: Ensure disc is NOT on the S (storage)
setting before installing it. Return
disc to S position after use.
IMPORTANT: Use only the DISC program or LOW setting when using the disc assemblies.
WARNING: Always unplug the base before cleaning.
Dishwasher: The bowl, lid, discs, nesting workbowl, and blade assemblies are
dishwasher safe. Ensure the blade assembly is removed from the bowl before
placing in the dishwasher. Exercise care when handling blade assemblies.
Hand-washing: Wash bowl, lid, discs, nesting workbowl, and blade assemblies in
warm, soapy water. Exercise care when washing the blade assemblies. Use a
dishwashing utensil with a handle to avoid direct hand contact with blades.
Rinse and air-dry thoroughly.
CLEANING
To Next Page
Loading...
Need help?
General
