Operating Instructions
Battery Installation
Insert the battery(s) as illustrated and screw to tighten the tail cap.
Note: After the battery insertion, the power indicator will flash to indicate the battery voltage. Please refer to the “Power
Indication” section of this manual for more details.
Warnings:
1. Ensure the battery(s) is/are inserted with the positive end towards the The product will not work if the battery(s)
is/are incorrectly inserted.
2. CAUTION! Possible dangerous radiation! Don’t look into the light! May be dangerous for your eyes.
3. When the power level is low, please stop using the product and replace or recharge the battery to prevent damage
to the
4. When the product is kept in a backpack or left unused for prolonged time, please remove all batteries to prevent
accidental activation or battery leakage.
5. DO NOT submerge the light into any liquid when it is hot. Doing so may cause irreparable damage to the light due
to the difference of air pressure inside and outside.
Charging Function
The P10iX is equipped with an intelligent charging system. As illustrated, after inserting the battery and tightening the tail
cap, use the USB cable to connect an external power supply (e.g. a USB adapter or other USB charging devices) to the
charging port to begin the charging process.
During the charging process, the power indicator will flash slowly to inform the user.
When the battery is fully charged, the P10iX will cease the charging process and the power indicator will become
steadily turned on to inform the user.
When the light is on, connecting to a power source will automatically turn the light off. The light will return to its
previous status when it is disconnected from the power source.
The charging time for a 21700 Li-ion battery (5,000mAh) is 3 hours 45 minutes. (Charged via the 5V/2A adapter)
Tactical Momentary Illumination
Half press and hold the Power Button to turn on the light momentarily. Release to turn it off.
On / Off
On: When the light is off, press the Power Button until a click sound is heard to turn it on.
Off: When the light is on, press the Power Button until a click sound is heard to turn it off.
To Next Page
Loading...
Need help?
General
