- 12 -
4.3.1 Connecting the door control cable (Main board J2)
■ Specifications of the cable and material
Housing Receptacle Cable
5264-06 5263PBT UL Cable, 24~28AWG
☞
Connection Note
①
Pay attention to terminal numbers when connecting the cable to
the connector.
②
Contact output is used when installing on the auto door. So make
sure to set the terminal [JP1] as OPEN. The factory default of
the terminal [JP1] is JUMPER.
③
Some locking devices may not have door monitoring signals.
☞ JP1 is positioned back of the terminal, beside product label.
JP1 is jumper for supplying power(12V) to the door
lock. If you use the external power supply, those
jumper must be removed before connecting the
To Next Page
Loading...
