Long press 3 seconds for indicator flash 1times
to normal,indicator flash 2times to lock right
FN(lock right FN is exchange right FN layer and
top layer),indicator flash 3 times to lock left
FN(lock left FN is exchange left FN layer and
top layer);Be enable in program mode
Shutdown doesn’t memory,Top layer is none FN
layer
※In program mode,the keyboard can be set 2 layer(left FN layer and right FN layer)
Bluetooth Operation Instruction
Keyboard can be paired 3 Bluetooth devices, and keyboard can be connect to different
devices to achieve rapid connection by press the key. Keyboard reset and default to
connect the last use of the device. If the keyboard is in the state of cable, you can
switch to the Bluetooth state by FN+_-; then one more time to click FN+_-to back to
the cable mode.
1. Bluetooth indicator instruction:
The indicator flash quickly, into pairing status.
The indicator flash slowly, into reconnect status.
The indicator is always on, int connectted status .and after 5 seconds, the
indicator is put out.
2. Bluetooth pair instruction:
Before into pairing,need to close the bluetooth of device that has paired to the keyboard.
For example,After the completion of the Bluetooth 1 paired phone a, if you need to match the
Bluetooth 2 and B cell phone, then need to first turn off the phone a Bluetooth, then FN+(9long by
3S, Bluetooth indicator lights flash, open the phone B Bluetooth, Bluetooth keyboard selection,
according to the prompts to enter pairing code and after pairing then open a phone's Bluetooth. At
this time through the FN+*8/(9 short press, the connection of mobile phone A/B switch. Similarly,
if you need to Bluetooth 3 and mobile phone 3 pairing, you need to turn off the phone A,
Bluetooth B mobile phone, until the completion of the pairing and then open.
3. The following operation is error operation:
The keyboard has been connected, FN+*8/(9/)0long press the matching operation, the
keyboard does not respond to the operation;
FN+*8/(9/)0short press the heavy even operation, if heavy even the equipment is not
matched for the null device, the keyboard does not respond to the operation, the indicator light
flash 2 under the return;
(3) Connected devices have not been off, forced into the pairing operation, which is the
keyboard will quickly connect to the paired devices, there will be 2 Bluetooth connection is the
same device. At this time, please turn off the Bluetooth device, and then re pairing one of the
bluetooth.
4. Battery indicator:
The battery indicator is below in the _-button. Always on for charging; Always off for
charging completion; flash for low power.
To Next Page
