USB,PS/2 Interface settings
Press “Left FN /Right FN + Backspace” for 5seconds ,indicator flash 1 times to USB,
indicator flash 2 times to auto identify for USB,PS/2.and restart the keyboard.The
default settings is set to USB.
Bluetooth Sleep and Power down settings
Press “Left FN/Right FN + T” for 5seconds ,indicator flash 1-3 times are power down
time set to 1-3 hours.The default power down time is set to 1 hours.
Clear Key Counter
Press “Left FN+Right FN + Delete” for 5seconds ,indicator flash,and the key counter
will be clear .
Restore factory settings
Press “ESC + L-ctrl + Backspace+ Right” for 5seconds will restore factory settings,
restore factory settings will restart keyboard.
2．Keyboard configuration
There are two modes for the keyboard, OFFICE mode and Custom mode.
OFFICE mode is also Standard mode, as for Custom mode, you can make different
configuration to the keyboard, the details for how to configuration and save under
custom mode are in below.
※
NOTE
：
Press the “Save” of main screen to save the configure when the configure be
completed.
How to configure keyboard:
Under OFFICE mode, press the “M” key on the top right corner , “M” light turn on,
then goes into custom mode. And goes into the OFFICE mode in the opposite way.
All keys on the keyboard are divided into no FN layer,left FN layer and right FN layer,
Left/right FN layer can output only when combine with left/right FN.
When finish the set up of all keys in programming software, to save and synchronize
the configure with keys, single click the “WriteKeys” in the main screen.
Single click the “Read configuration” in the main screen, it will read the
standard configuration of OFFICE mode when under the OFFICE mode and
To Next Page
