EasyManua.ls Logo

NIZ Micro 82 - USB,PS;2 Interface settings; Bluetooth Sleep and Power down settings; Clear Key Counter; Restore factory settings

NIZ Micro 82
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
by 3S, Bluetooth indicator lights flash, open the phone B Bluetooth, Bluetooth keyboard selection,
according to the prompts to enter pairing code and after pairing then open a phone's Bluetooth. At
this time through the FN+F9/F10 short press, the connection of mobile phone A/B switch.
Similarly, if you need to Bluetooth 3 and mobile phone 3 pairing, you need to turn off the phone A,
Bluetooth B mobile phone, until the completion of the pairing and then open.
3. The following operation is error operation:
The keyboard has been connected, FN+F9/F10/F11 long press the matching operation, the
keyboard does not respond to the operation;
FN+F9/F10/F11 short press the heavy even operation, if heavy even the equipment is not
matched for the null device, the keyboard does not respond to the operation, the indicator light
flash 2 under the return;
(3) Connected devices have not been off, forced into the pairing operation, which is the
keyboard will quickly connect to the paired devices, there will be 2 Bluetooth connection is the
same device. At this time, please turn off the Bluetooth device, and then re pairing one of the
bluetooth.
4. Battery indicator:
The battery indicator is below in the F12button. Always on for charging; Always off for
charging completion; flash for low power.
USB,PS/2 Interface settings
Press “FN + Backspace” for 5seconds ,indicator flash 1 times to USB, indicator flash
2 times to auto identify for USB,PS/2.and restart the keyboard.The default settings is
set to USB.
Bluetooth Sleep and Power down settings
Press “FN + T” for 5seconds ,indicator flash 1-3 times are power down time set to 1-3
hours.The default power down time is set to 1 hours.
Clear Key Counter
Press “FN + Delete” for 5seconds ,indicator flash,and the key counter will be clear .
Restore factory settings
Press “ESC + L-ctrl + Delete+ Right” for 5seconds will restore factory settings,
restore factory settings will restart keyboard.
2.Keyboard configuration
There are two modes for the keyboard, OFFICE mode and Custom mode.