Noblelift PSE15L-C 3600

Questions and Answers

L
Laura BridgesAug 5, 2025
Why won't my Noblelift Forklifts lift loads?
- S
  Stephanie WallaceAug 6, 2025
  There are several reasons why your Noblelift Forklifts might not be lifting loads. It could be that the load weight is too high, exceeding the rated capacity, so ensure you are operating within the specified limits. Another cause may be a discharged battery, so you should charge the battery. Also, check the lifting fuse and replace it if faulty. Low hydraulic oil level or oil leakage from hoses or the cylinder can also prevent lifting; refill the hydraulic oil and repair any seal issues.
M
mariabrownAug 9, 2025
What to check if my Noblelift PSE15L-C 3600 Forklifts are not working?
- K
  Kevin MayAug 10, 2025
  If your Noblelift Forklifts are not working, begin by checking the fuses and replace them if necessary. Ensure the battery is charged. Verify that the truck is powered on by checking the emergency switch, key switch, and other relevant switches. Also, make sure that you are following the correct sequence of operations: move the tiller bar to the braking position, return it to the operating position, and then operate the accelerator.
K
Kevin OconnellAug 14, 2025
Why is my Noblelift Forklifts stacker traveling very slowly?
- J
  Jack WardAug 14, 2025
  If your Noblelift Forklifts stacker is moving very slowly, there are several potential causes. The battery might be discharged, so check its status using the discharge indicator. The electromagnetic brake could be engaged, so inspect the brake. Also, the tiller cables may be disconnected or damaged, so examine the cables and connectors.
H
Henry YangAug 18, 2025
What to do if Noblelift Forklifts loads cannot be lowered?
- M
  Misty HowardAug 18, 2025
  If the loads on your Noblelift Forklifts cannot be lowered, it could be due to dirty oil blocking the control valve. Inspect the hydraulic oil, clean the control valve, and replace the hydraulic oil if needed. Alternatively, the lowering electromagnetic valve may not be activated or could be damaged, so check or replace it.
N
Nicole KerrAug 23, 2025
Why does my Noblelift PSE15L-C 3600 stacker start up suddenly?
- D
  David BradleyAug 23, 2025
  If your Noblelift Forklifts stacker starts up suddenly, the controller might be damaged and require replacement. Another possibility is that the accelerator cannot return to its neutral position, in which case you should repair or replace the accelerator.
L
Lawrence LivingstonAug 27, 2025
Why does my Noblelift PSE15L-C 3600 Forklifts stacker only travel in one direction?
- N
  Natalie Martinez DVMAug 27, 2025
  If your Noblelift Forklifts stacker only travels in one direction, it may be because the accelerator and its connectors are damaged. Check the accelerator and the connectors.
A
Andrew LloydAug 31, 2025
How to fix oil suction failure in Noblelift Forklifts?
- J
  Jeffrey AndrewsSep 1, 2025
  Oil suction failure in Noblelift Forklifts can occur due to an excessive quantity of oil. Reduce the oil quantity to resolve this issue.