1.) Connect the positive
(red)
battery clamp
or
eyelet
terminal connector
to
the positive (POS,P,+) battery
terminal.
2.) Connect the negative (black) battery clamp or eyelet
terminal connector to the negative (NEG,N,-) battery
terminal
or
vehicle chassis.
3.) Connect the battery charger's
AC
power
plug into a
suitable electrical outlet. Do not face
the
battery when
making this connection.
4.) When disconnecting the battery charger, disconnect
in the reverse sequence, removing the negative first (or
positive first for positive ground systems).
Begin Charging.
1.) Verify the voltage and chemistry
of
the battery.
2.) Confirm that you have connected the battery clamps
or
eyelet
te
rminal connectors properly and the AC power plug
is plugged into an electrical outlet.
3.) The charger will begin
in
Standby mode, indicated by
an orange LED.
In
Standby, the charger is
not
providing
any power.
4.) Press the
mode
button
to
toggle
to
the appropriate
charge
mode
(press and hold for three seconds
to
enter an
advanced charge mode) for the voltage and chemistry
of
your battery.
5.) The
mode
LED will illuminate the selected charge
mode
and the Charge LEOs will illuminate (depending on the
health
of
the battery) indicating the charging process has
started.
6.) The charger can
now
be left connected
to
the battery at
all
times
to
provide maintenance charging.
To Next Page
Loading...
Need help?
General
