12
6. Use the same method to put the battery
retainer back in.
Indicator light flashes
green once
Note:
- The warranty will be void if the battery was not changed by a professional and water damage occurs.
- If you get your battery changed by a professional, please keep the receipt as proof.
- When changing the battery yourself, make sure to close the case properly.If closed improperly,
you risk impairing the watch’s waterproof resistance.
- We suggest that you synchronize the data before changing your battery, in case of data loss.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
HOW TO CHANGE THE STRAP
1. Move the quick release spring bar to
remove the strap.
2. Take your new strap and insert one side
of the spring bar into the lug end.
3. Push the spring bar into the other side,
your new strap is installed!
5. Use a sharp headed tool to gently press
the reset button once, the indicator light
will then flash green once.
7. Install the watch case and turn it until
it's tight. You can then use your watch
normally again!
To Next Page
Loading...
