Dead
Dead zone around zero.
Dead>0: Display readings smaller than Dead are rounded to zero.
Dead=0: Negative readings are prevented.
Dead<0: Both positive and negative readings are displayed.
2211KCI configuration menu
Dec
Number of digits after the decimal point. E.g. with value of 1, the reading is displayed with one
digit after the decimal point.
If the dec setting is negative, the corresponding number of last digits is rounded to zero.
Example: Dec= -2, the display will step 0, 100, 200...
Lo Offset that is added to the display reading. May be negative. Almost always 0.
Hi 1 Displayed reading at the maximum input signal on channel 1.
Hi 2 Displayed reading at the maximum input signal on channel 2. When there is a signal on both
channels, the sum is displayed.
Lopass Damping, will slow down display fluctuations. Set the time constant (63% of the final change) in
seconds. Fast operation = 0.
Dead
Dead zone around zero.
Dead>0: Display readings smaller than Dead are rounded to zero.
Dead=0: Negative readings are prevented.
Dead<0: Both positive and negative readings are displayed.
Tare Tare value that is subtracted from every reading. Mainly for viewing, but can be edited too.
10
To Next Page
Loading...