13
You can enter up to 16 characters (8 per each line of the
display). Each “space’’ and “hyphen’’ entry is included as
part of the maximum 16 characters.
D Store the name in a desired memory location.
E To exit alpha mode, press ALPHA.
Note: If you begin your memory store procedure in alpha
mode, after you have finished keying in a name, exit alpha
mode by pressing ALPHA again. Now you can key in
numbers.
If you make a mistake while keying in a name or a number,
you can correct it as follows:
A Press CLR to delete the last number or digit.
B Press and hold CLR to clear the whole display.
Note: This clears both the name and the number entered.
The phone can display up to 16 digits. If you key in more than
this, the first digits will disappear off the side of the display.
If you want to check these hidden digits, press and hold RCL
and they will appear on the display. When you release the
RCL key, the original display will reappear.
Remember to clear the whole display (press and hold
CLR) after having displayed a long number.
A Press and hold CLR to clear the display.
B Press STO. The display will read STORE.
C Key in the number of the memory location you want to
delete. The message REPLACE CONTENT? will appear.
D Press STO. The message STORED and the memory
location number will be displayed briefly, confirming that
the memory location has been deleted. (Also alpha
characters are deleted from the memory location).
A Press RCL. The display will read RECALL.
B Key in the memory location number (e.g. 0,2). The
telephone number stored in that memory location will
RECALLING INFO. BY MEMORY LOCATION NUMBER
DELETING INFORMATION FROM A MEMORY LOCATION
DISPLAYING “HIDDEN” NUMBERS
EDITING NAMES OR NUMBERS
To Next Page
Loading...
