2.10 AUTOPIN SECURITY FEATURE
The Nokia 32 terminal has an AutoPIN security feature. It saves the PIN code in the
terminal’s memory when the code is entered for the first time or when the code is changed.
In addition, the AutoPIN feature enables device recovery after occasional power cuts without
on-site intervention. The terminal enters the PIN code automatically the next time it switches
on and requests the PIN code.
Use of the SIM card in other GSM terminals or mobile phones can be prevented. The user
does not have to know the PIN code. However, other SIM cards can be used with the
terminal. The AutoPIN feature can be deactivated using the Nokia 32 Configurator software
(menu: GSM Security -> PIN Code Settings).
Figure 5: Changing PIN code settings
The default value is that the AutoPIN feature is active.
3. ACTIVATING AND USING CONFIGURATION MODE
Changing some Nokia 32 terminal settings is also possible using a normal telephone set.
This chapter describes how this so-called configuration mode is activated and how it is used.
To activate the configuration mode, key in **####**.
The configuration mode is protected with a four-digit access code. When the configuration
mode has been activated, the Nokia 32 terminal requests for an access code for changing
the settings. The default code is 1234. To change the default access code, use the Nokia 32
Configurator Software.
To enter the access code, key in AccessCode#.
In other words, if you use the default access code, dial **####**1234# to activate the
configuration mode.
3.1 CHANGING THE LOOP INTERRUPTION TIME
The loop interruption time is used to indicate call disconnection.
The default loop interruption time is 300 milliseconds. Key in a zero to disable the loop
interruption. After you have keyed in the interruption time, the Nokia 32 terminal returns to
the configuration mode.
To Next Page
Loading...
Need help?
General
