445N
9
1.5. Monitor Connection
Make sure that the monitor is disconnected from mains and the power switches of the com-
puter and all attached devices are turned off before connecting the monitor.
-- Connect the signal cable plug to the videocontroller connector at the back of the computer.
-- Tighten the screws on the plug by hand.
-- Connect the power cord first to the monitor and then to a grounded power outlet.
-- Do not use any adapter when connecting signal cable to your computer.
-- Do not extend t he signal cable with extension lead. The DDC signals will not accept extended
cable.
--- Display controller must be compatible for External +5 V, In SMK001 E---version External +5 V is
not necessary but the monitor works also with it
Signal connector
Pin Signal
1 -- >RV Redvideo
2 -- > GV Green video
3 -- > BV Blue video
4<-- ID2 ID 2 (tied to LG)
5 DDC return)
6 RG Red ground
7 GG Green ground
8 BG Blue ground
9 -- > DDC +5V
10 Sync grounds
11 <-- Ground)
12 <-- SDA DDC SDA
13 -- > Hs Horizontal synchronization, Composite synchronization
14 -- > Vs Vertical synchronization
15 <-- SCL DDC SCL
1 5
6 1011 15
To Next Page
Loading...
