Nokia 445PRO - 4.2.4. Memory settings and Initializing the Replacement IC402 on SMA board; 4.2.5. Storing the Adjustments; 4.2.6. Exit from Service Mode

445N
19
GEOMETRY...
GREYSCALE...
SHARPNESS
PRODUCT INFORMATION . . .
MEMORY SETTINGS . . .
CONTRAST
MIN CONTRAST
MAX CONTRAST
BRIGHTNESS
G2
RED BLACK LEVEL
GREEN BLACK LEVEL
BLUE BLACK LEVEL
RED AMP.
GREEN AMP.
BLUE AMP.
BCL ADJUST
EXIT
00: 1600x1200 85HZ
MODEL: HP P1110
SERIAL NUMBER FI92500061
POWER ON HOURS 23
S T A N D --- B Y H O U R S 0
SUSPEND HOURS 0
ACTIVE--- OFF HOURS 0
FIRMWARE 0.19
EXIT
TYPE : O
CUSTOM COLOR: 1
DDC : EXT (24LC21)
INITIALIZE EEPROM
INIT BURN IN TEST
EXIT
GEOMETRY...
GREYSCALE...
SHARPNESS
PRODUCT INFORMATION . . .
MEMORY SETTINGS . . .
VERTICAL CONV
HORIZONTAL CONV
MOIRE
TOP AND BOTTOM EDGES
TOP RIGHT CORNER
BOTTOM RIGHT CORNER
TOP LEFT CORNER
BOTTOM LEFT CORNER
EXIT
00: 1600x1200 85HZ
GEOMETRY...
GREYSCALE...
SHARPNESS
PRODUCT INFORMATION . . .
MEMORY SETTINGS . . .
00: 1600x1200 85HZ
GEOMETRY...
GREYSCALE...
SHARPNESS
PRODUCT INFORMATION . . .
MEMORY SETTINGS . . .
00: 1600x1200 85HZ
4.2.4. Memory settings and Initializing the Replacement IC402 on SMA board
If the memory for factory adj ustments is replaced, it must be initialized. D uring initializing all memory
locations are written with approximate values. They must be updated in service mode as explained
in the chapter ’Adjustment Procedure’.
- INTIALIZE EEPROM always with using display mode no 00! (107.10 kHz/85 Hz (NCE791))
- Select I NITIALIZE EEPROM.
- After initializing switch OFF the monitor.
- Activate service mode as explained before.
- Select Memory settings ---menu.
- Select Monitor type O, custom color 1 and DDC (EXT 24LC21)
Caution
Initializing of a programmed memory IC deletes all user a nd factory made adjustments.
4.2.5. Storing the Adjustments
When the adjustment is ready, return to t he menu by pushing the button. Adjustement will be
stored automatically.
4.2.6. Exit from Service Mode
Switch off the monitor.