17
English
Switch to a handwriting
input mode
You can switch to a handwriting
input mode in two ways:
• Tap the corresponding touch-
key with the stylus to switch to
, , , or .
• Press Options if it is available,
and select the desired mode
from the list.
■ Recognition timeout
Recognition timeout is the
maximum interval time allowed
between two strokes input when
writing a character or letter. Every
time you finish a stroke and lift the
stylus from the touch-board, the
phone begins to count time. If you
do not write the next stroke within
the timeout, it’s considered that you
have finished writing the character
or letter, and the phone begins to
recognise the strokes, and displays
a list of candidates.
The default recognition timeout is
0.5 seconds. If you want to write
faster or slower, you can change the
timeout in Settings, Phone settings,
Recognition timeout. Refer to
“Recognition timeout”, 52.
■ Use gestures
You can write several gestures for
certain functions. The phone
recognises the gestures in the same
way as it recognises the strokes.
The gestures include: Space, Enter,
Clear, and Repeat. See the table
below. You can use (Repeat)
only in mode, but other
gestures in all handwriting input
modes.
Full-width punctu-
ation marks &
symbols
Full-width punctuation marks and sym-
bols
Half-width punctu-
ation marks &
symbols
Half-width punctuation marks and sym-
bols
a. Available only in phones sold to mainland China, Indonesia, Malaysia, Singapore,
and Vietnam.
b. Available only in phones sold to China Hong Kong SAR, and China Taiwan.
Mode Indicator Recognition scope
RH-4_FCC_2003-4-16.fm Page 17 Friday, April 18, 2003 4:34 PM
To Next Page
Loading...
