41
English
WAP service that you want to
use, press for a dot, and
press OK.
• Session mode. Select
Permanent or Temporary.
• Data bearer. Select GPRS.
• GPRS access point. Enter the
access point name to
establish a connection to a
GPRS network and press
OK. Contact your network
operator or service provider
for the access point name.
• IP address. Enter the address,
press for a dot, and press
OK. You obtain the IP
address from your network
operator or service provider.
• Authentication type. Select
Secure or Normal.
• User name. Enter the user
name and press OK.
• Password. Key in the
password and press OK.
• Allow adverts. You can allow or
reject advertisements. This
setting is not shown if the Allow
multimedia reception is set to
No.
To receive the multimedia
connection settings as a text
message
You may be able to receive the
service settings as a text message
from the network operator or
service provider that offers the
WAP service that you want to use.
For more information, contact your
network operator or service
provider. You can also visit Club
Nokia’s website
(www.club.nokia.com), availability
may vary by country.
Font size setting
To select the font size for reading
and writing messages, press Menu,
and select Messages, Message
settings, Other settings and Font
size.
Service commands
Press Menu, and select Messages
and Service commands. Enter and
send service requests (also known
as USSD commands), such as
activation commands for network
services, to your service provider
(network service).
■ Call register
(Menu 2)
The phone registers the phone
numbers of missed, received and
dialled calls, and the approximate
length and cost of your calls.
The phone registers missed and
received calls only if the network
supports these functions, the phone
is switched on and within the
network’s service area.
When you press Options in the
Missed calls, Received calls and
RH-4_FCC_2003-4-16.fm Page 41 Friday, April 18, 2003 4:34 PM
To Next Page
Loading...
